This High Pole is ideal for super loads, and other instances when you need that extra height. It retracts to 77" and extends up to 30'. Our non-conductive fiberglass is safer than metal poles, and will not rust, chip, or peel.

Every High Pole Pro comes with a Striker Mount, fiberglass striker rod marked at 6" from the top, and an extra striker rod just in case. Slip the Striker Mount over and onto the high pole and fasten with the hex wrench provided. Now place the Striker Rod into the smaller hole in top end of the Striker Mount as much as desired. Be sure to insert at least 12" of the striker rod into the mount. Fasten the rod into position by tightening the other two set screws with the hex wrench.

The stainless steel security clamps will not rust, and are sized for each section of the high pole. This allows you to keep the clamps on the high pole when not in use. We provide a handy key for securing the clamps to the high pole. The clamp key has a hole for fastening to your key ring so it does not get misplaced.

The shock cap should be inserted into the bottom section of the high pole so when in transit the vibrations encountered during travel do not cause injury to the high pole. Extra shock caps can be purchased if needed.

The heavy duty poly bag will help you keep your High Pole 630Pro protected when not in use. Thank you for choosing the High Pole 630Pro. You can be sure that you have the highest quality fiberglass high pole available. Made in the USA!