Five (5) Replacement Sure Grip™ Pole Handles

Set Of Five Sure Grip™ Pole Handles

The complete set of handles for for your fiberglass Wonder Pole®
No glue or epoxy is needed to replace your handles.

Each set comes with five Sure Grip handles 1 through 5, and instructions.
The sure-grip-handle #1 is designed to fit the lower half part fits onto the 1″ pole section, and the top screw joint tightens to the 3/4″ section of the Wonder Pole.
The sure-grip-handle #2 lower half part fits onto the 1 1/4″ pole section, and the top screw joint tightens to the 1″ section of the Wonder Pole.
The sure-grip-handle #3 lower half part fits onto the 1 1/2″ pole section, and the top screw joint tightens to the 1 1/4″ section of the Wonder Pole.
The sure-grip-handle #4 lower half part fits onto the 1 3/4″ pole section, and the top screw joint tightens to the 1 1/2″ section of the Wonder Pole.
The sure-grip-handle #5 lower half part fits onto the 2″ pole section, and the top screw joint tightens to the 1 3/4″ section of the Wonder Pole.
A polyester tape is supplied to wrap around the pole section prior placing the Sure Grip handle on the pole. It may not be needed depending on the use and discretion of the user.

How to replace a Sure Grip handle.

To replace just the pole section open the Sure Grip™ and remove the pole section by slowly drawing our past the stop marker tape (This may require a twisting and pushing motion to get the taped portion past the collar fingers). Insert the new section back into the pole using the same twisting motion as you did when removing the old section.

Now screw close the Sure Grip™ and back it off one complete turn. Using the wood mallet, strike the top part of the Sure Grip until it is fully seated on the pole section. Be careful not to strike to hard as you may damage the threads. Once this is done unscrew the top Sure Grip™ collar and reinsert the above pole section.

If you experience any problems or need any assistance, please contact us at 1-503-585-1179 or via our web contact form.

If you are replacing just the top ¾”pole section you can loosen the Sure Grip™ and simply slide the section out through the bottom of the pole (Reverse procedure to replace with the new section ¾” section).